Process flow

Granite raw material by ZSW490 * 130 feeder uniform feed, into the PEW1100 hydraulic jaw crusher for rough break, and then into the CSB240 cone crusher for the second break, two broken out of the stone into the 2Y2460 shaker screening, 2 broken, less than 150mm finished material for three broken, more than 40mm again broken, less than 40mm into the VSI5X-1145 impact crusher shaping, finished 0-5mm, 5-10mm, 10-20mm, 20-31.5mm quality bone Material, the current production line production, grain type is good, is an exemplary granite processing production line.

Equipment configuration advantages

1. The configuration of the latest European version of the hydraulic jaw broken, V-shaped structure crushing chamber, feed large, bite force, output; wedge hydraulic adjustment discharge port size, easy to use, saving commissioning time, centralized lubrication, equipment Maintenance convenient and quick.

2.Three-break hydraulic cylinder cone crusher, the higher speed and stroke combined with the HPT crusher rated power and greatly improved through capacity, improve the crushing ratio and production efficiency. At the same time, through the use of inter-granular lamination principle designed special crushing chamber and its match with the speed, significantly improved product fines ratio and cube content, a significant reduction in the needle-like sheet material. Multi-cylinder hydraulic cone crusher with all-thin oil lubrication, no manual fuel per shift, saving labor costs, maintenance and repair equipment is also very simple and convenient, reducing production and operating costs.

3. The production line with three broken, broken at all levels to achieve maximum crushing ratio optimization, broken in the middle after the second screening, direct part of the finished material, reducing the crushing pressure of the three cone crusher, so that the entire production line To achieve maximum optimization.